Sensor Web Interface

Home
Settings
Network
Email
Cloud

Error:

Connection to the Sensor was interrupted.

Current State

Change Temperature Unit

Sensor Configuration

Sensor Name/ Description

Shows in alerts

Illumination range: 0 to 3200 Lux. Send Alarm When

Illumination is Less than (Value in Lux)

Or Illumination is Greater than:(Value in Lux)

And stays there for: (Value in Seconds)

Alarm reset time: (Value in Seconds)

Temperature Sensor

Temperature range: -40 to + 255 °F. Send Alarm When

Temperature is Less than (Value in Degrees)

Or Temperature is Greater than(Value in Degrees)

And stays there for: (Value in Seconds)

Alarm reset time: (Value in Seconds)

Relative Humidity range: 0 to 100%. Send Alarm When

Humidity is Less than(Value in %)

Or Humidity is Greater than (Value in %)

And stays there for:(Value in Seconds)

Alarm reset time:(Value in Seconds)

CO2 range: 400 to 5000 ppm. Send Alarm When

CO2 is Less than (Value in ppm)

Or CO2 is Greater than (Value in ppm)

And stays there for:(Value in Seconds)

Alarm reset time:(Value in Seconds)

Thermistor range: -58 to 302 °F. Send Alarm When

Temperature is Less than (Value in Degrees)

Or Temperature is Greater than (Value in Degrees)

And stays there for: (Value in Seconds)

Alarm reset time: (Value in Seconds)

Baud Rate

Set your own key/ value pairs.

PIR Sensor Settings Hidden

Schedule Start Time:

Stop Time:

PIR Trip Time: Sec.

Return Time: Sec.

PIR Schedule:

PIR Action:

Motion Sensor

Motion Sensor is

ON

OFF

Always

As Scheduled

Day of week

S M T W T F S

Schedule 1 Start Time

(Eg: 11:30)

Schedule 1 End Time

(Eg: 14:30)

Add another schedule.

Schedule 2 Start Time

(Eg: 17:30)

Schedule 2 End Time

(Eg: 19:30)

Keep Sensor active all day on unchecked weekdays.

Sensitivity

Motion is Detected.No Motion Detected for (Enter time below, HH:MM)

Door/ Contact/ Switch Sensor

Change Sensor Mode

Normally Open (Alarm when sensor switch closes). Normally Closed (Alarm when sensor switch opens).

Level Sensor

Change Sensor Mode

Normally Low (Alarm when high). Normally High (Alarm when low).

Continuous Level Sensor

Select Level Unit

Measure

Sensor to Floor Distance (cm)

Monitor

Enable Data Filtering.

Filter Coefficient (0-655)

Send Alerts When

Level is Less than

Or Greater than

for more than: (Value in Seconds)

Alarm Reset Delay: (Value in Seconds)

Water/ Fluid/ Leak Sensor

Select Sensor type

Change Sensor Mode

Normally Dry (Alarm when wet). Normally Wet (Alarm when dry).

Electric Load Sensor Settings

Change Sensor Mode

Normally Off (Alarm when ON). Normally ON (Alarm when OFF).

Alarm Delay Settings

Add more delay before alarm trips (Value in seconds)

Add more delay before alarm resets (Value in seconds)

Buzzer

Enable Audible Alerts.

Snooze after (Enter Minutes. Leave blank to not snooze.)

General Settings

Send Alarm Emails.
Send Email when Alarm Resets.

Resend Alert messages in (minutes)

Send Daily Status Email at (Set time below. Eg:20:00)

Notes on Sensor Settings.